RPi B+/2/3 cases

RASPBERRY PI NOT INCLUDED - Redesigned case now has sufficient space for heat sinks

The One Nine Design Raspberry Pi Case is a three piece, stylish case designed to keep your Raspberry Pi safe but enable easy access to the GPIO. It comes in three pieces:

1. A moulded base, with airflow holes and 55mm spaced M3 mounting holes
2. A slot over cover, which fits over the Pi, enclosing it, but leaving all ports like the GPIO free for hacking.
3. A cover piece, which clips in and protects the Pi from dust and exposure.

This case also features two slots for holding the Raspberry Pi Camera module!

• 3 Piece "Easy-Access" Design
• Embossed Raspberry Pi Logo
• SD Card Access
• Clip Shut Case
• Labelled Ports
• Top & Side Location Camera Holder
• Non Slip Feet
• 55mm M3 Mounting Holes
• Full Gloss ABS Plastic
• External Height: 31mm
• External Width: 64mm
• External Length: 95mm
• ROHS Compliant

• 1 x One Nine Design Case

Spice up your Flick Large board with a stylish white and orange Flick Large case! This vibrant and durable case is made up of two parts; an orange base and a slide-on white lid.

This lid can be used in two different setups in either an open or closed position. This allows you to hide your I2C device and Flick Large, or keep it visible to the world. Flick works through materials such as acrylic, wood and glass so our plastic case (even when the lid is in the closed position) will not negatively impact any of the fun you can have with Flick!

GPIO access and suction cups

The Flick Large case features four suction cups for installation in the bottom four corners of the case. Use the suction cups to mount the case onto many different surfaces such as glass, plastic, or wood and still be removed easily.

Perhaps you want to set up your Flick Large & I2C device to only allow entry through a door if you swipe the right pattern - with this case, you could mount it right next to the door without the need to drill any holes or hammer any nails.

Features:

• 4 x suction cups
• 1 x orange base
• 1 x white lid
• Dimensions:19cm x 12.5cm x 1cm

Case assembly guide

Need help assembling your Flick Large case? Check out our quick start and FAQ page here that will guide you through the process of piecing it together.

Flick Software

Visit our Flick GitHub page and acquire all the software you need to get up and running with your brand new Flick Large & Case.

4 x Acrylic Board not including Raspberry Pi boards)
1 x set Screws and Nuts
4 x Cooling Fans
1 x Fan Cover

2 x Acrylic Board (not including Raspberry Pi board)
1 x set Screws and Nuts
1 x Cooling Fan
1 x Fan Cover