Zero Power supplies

Raspberry Pi Zero Power Supplies
Sort By:  
Raspberry Pi Official Pi3/ZERO/Pico Micro USB Power Supply 5.1V 2.5A square white (Pi3 Power 2.5A square White)


You will find a South African plug adapter here

This PSU supports up to 2.5A of current, so it won't let you down when powering hungry devices through your Raspberry Pi 3 Model B, Zero and Pico



- Output voltage: 5.1V DC
- Minimum load current: 0.0A
- Nominal load current: 2.5A
- Maximum power: 12.5W
- Load regulation: ±5%
- Line regulation: ±2%
- Ripple & noise: 120mVp-p
- Rise time: 100ms maximum to regulation limits for DC outputs
- Turn-on delay: 3000ms maximum at nominal input AC voltage and full load
- Protection: Short circuit protection

Overcurrent protection
- Efficiency: 80.73% minimum (output current from 100%, 75%, 50%, 25%)
- Output cable: 1.5m 18AWG
- Output connector: mirco USB

- Voltage range: 100–240Vac (rated) 96–264Vac (operating)
- Frequency: 50/60Hz ±3Hz
- Current: 0.5A maximum
- Power consumption (no load): 0.075W maximum
- Inrush current: No damage shall occur and the input fuse shall not blow

What's in the box?

1 x Official Power Supply

• This product should be operated in a well-ventilated environment.
• The connection of incompatible devices to this power supply may affect compliance, result in damage to the unit and invalidate the warranty.

To avoid malfunction or damage to this product please observe the following:
• Do not expose to water or moisture, or place on a conductive surface whilst in operation.
• Do not expose to heat from any source; this is designed for reliable operation at normal ambient room temperatures.
• Do not attempt to open or remove the power supply case.

R159.90  Inc VAT
Li-ion Battery HAT for Raspberry Pi, 5V Output, Quick Charge (Battery hat zero)

The Li-ion Battery HAT integrates SW6106 power bank management chip, allows providing 5V regulated power supply to your Pi from a 14500 battery, turnes the Pi into a portable device. It will charge the battery as well, supports bi-directional quick charge. This module can be used as a universal mini power bank, also works with other 5V devices.

  • Onboard SW6106 chip, supports bi-directional quick charge, supports multi quick charge protocols like PD/QC/FCP/PE/SFCP
  • Lithium battery protection circuitry, provides reverse protection, over charge/discharge protection, over current protection, and short circuit protection
  • Onboard indicators: quick charge, warning, and power capacity
  • Output voltage: 5V
  • Applicable battery: 3.7V 14500 lithium battery (4.2V when full charged)
  • Dimension: 65mm × 30mm
  • Mounting hole size: 3.0mm
What's on Board

  1. Raspberry Pi GPIO connector: for connecting Raspberry Pi
  2. SW6106 power management chip
  3. USB Type-C connector: battery charge/power output
  4. USB Type-A connector:power output
  5. Micro USB connector:battery charge
  6. Raspberry Pi power switch
  7. Battery warning indicator: on when the battery is reverse
  8. Battery power capacity indicator: 5x LEDs to indicate the power capacity and charging status
  9. Quick charge indicator: on when quick charging
  10. 14500 battery holder

Development Resources

Wiki :

R329.90  Inc VAT
Per Page      1 - 2 of 2
  • 1